RE:About gm configuration!

   Thanks for your attention really!
   But it is sure your check-up list is fine. 
   The OS in the node running the mapper and gm_allsize are linux6.2,and the other nodes are linux7 which 
have no GM.But if I disconnect other nodes from the switch and only connnect the switch to the node running the 
mapper.The problem is the same.Anything is wrong.
 
Best regards!


>>
>> 1. ./mapper active.args
>>    (the result is as follows:)
>>    starting to map.My clock...
>>    mapper node is disconnected. I don't know what to do.
>
>Are you sure the node running the mapper has a myrinet card ? the GM
>module is loaded on this node ? the cable is connected to the card ? the
>other end to the switch ?
>If this check-up list is fine, the mapper should find at least the
>mapper's node and the switch.
>
>> 2. gm_allsize -v
>>    (the result is as follows:)
>>    #opening board 0 port 2.sending to port 2
>>    #...
>>    #...
>>    Error:  could not determine node id.
>
>It's normal without a set of routes from the mapper. The mapper gives
>the node id to each card.
>
>Regards.
>
>-- 
>Patrick Geoffray
>

_____________________________________________
263Commail£¬ÆóÒµµÄµç×ÓÓʼþר¼Ò http://mail.263.net