Re: [Myrinet] "bad globals length" error
sandhya senapathi <[email protected]>
| Newsgroups | gmane.network.myrinet.general |
|---|---|
| Message-ID | <[email protected]> |
On Sat, 19 Jan 2002, Greg Lindahl wrote: > On Sat, Jan 19, 2002 at 12:41:01AM -0500, sandhya senapathi wrote: > > > wouldnt doing a make clean and then a make do this ? would i have to do > > anything else ? > > You'd need to install the special lanai-gcc that's needed for the RISC > processor on the lanai card. I suspect that without lanai-gcc, make > would rebuild GM and then fail to rebuild the lanai, and if you didn't > pay attention to the error message, subsequently trying to use that GM > and give you the "incompatible global length" error. > lanai-gcc is installed and the variable LANAI_GCC in the Makefile points to the right path. But something's wrong. When I run make, lanai-gcc is never run, only gcc. So the lanai-gcc is installed but its never used. I didnt change anything in the Makefile. The version Im using is gm-1.5. What is wrong ? sandhya > g > > _______________________________________________ > Myrinet mailing list > [email protected] > http://email.osc.edu/mailman/listinfo/myrinet >