Re: Disable specifc OIDs in MIB
Robert Story <[email protected]>
| Newsgroups | gmane.network.net-snmp.devel |
|---|---|
| Message-ID | <[email protected]> |
On Tue, 3 Jul 2018 19:05:59 +0530 Thommandra wrote: TG> - How can we disable an OID from snmpwalk output? For snmpd, you can configure VACM views in snmpd.conf to exclude certain OIDS. It's not very intuitive, but should be possible. For the client, there isn't a way to not query for something during a snmpwalk. TG> c) Can we disable an entire MIB during compile time? Ex: TCP or TG> UDP-MIB Yes. You can disable MIBs via configure and at run-time. TG> Also, I see that after moving to 5.7.3 snmpwalk times-out TG> after walking the VRRP-MIB though there is data beyond that TG> OID. And this is happening always when there is data in TG> VrrpOperTable. We don't implement the VRRP-MIB, so you'll have to check with the device vendor. Increasing the timeout may help. Robert ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot