Re: Help setting up snmpd.conf for encrypted V3 access only
Dave Shield <[email protected]>
| Newsgroups | gmane.network.net-snmp.user |
|---|---|
| Message-ID | <[email protected]> |
On Fri, 2005-10-07 at 15:17 -0700, Joe Asdf wrote: > I can't figure out how to enforce that users connect to my > agent via encrypted & authenticated SNMPv3. > > Currently, I have a fairly simple snmpd.conf: > __________________________ > rouser joe_username auth .1.3.6.1.4.1.bla.bla.bla First thing - for *encrypted* SNMPv3, you need to specify "priv" instead of "auth" > The problem is that I can walk my agent specifying SNMP v1 or v2 That sounds as if there's some other access control settings somewhere, allowing community-based access. Try starting the agent using 'snmpd -f -Le -Dread_config' and examine the output for any unexpected configuration. Dave ------------------------------------------------------- This SF.Net email is sponsored by: Power Architecture Resource Center: Free content, downloads, discussions, and more. http://solutions.newsforge.com/ibmarch.tmpl _______________________________________________ Net-snmp-users mailing list [email protected] Please see the following page to unsubscribe or change other options: https://lists.sourceforge.net/lists/listinfo/net-snmp-users