Re: How can I test perl modules?

Radek Vokál wrote:
> I've tried to run sample perl module from
> 
> http://net-snmp.sourceforge.net/tutorial/tutorial-5/toolkit/perl/perl_module.pl
> 
> I've also modified the snmpd.conf to load the module
> 
> # head /etc/snmp/snmpd.conf
> perl do "/etc/snmp/perl_module/pl";
> 
> snmpd doesn't display any error, so I guess it's loaded .. 

Do the following: kill/stop snmpd (if running as daemon), open a
shell/xterm/etc and run snmpd in foreground:
$ snmpd -f -Lsd -Lf /var/log/snmpd.log -p /var/run/snmpd -a

Now you should see messages like:
"starting perl_module.pl
perl_module.pl loaded ok"

In general your perl module can write to STDERR and it will be dumped
into the former shell so it is a quick method for debugging. Note also
that when you modify the module snmpd should be restarted, so you simply
go to the shell, hit ctrl-c, and launch snmpd (in foreground) again.

Regards,
-Roman


-------------------------------------------------------
This SF.Net email is sponsored by:
Power Architecture Resource Center: Free content, downloads, discussions,
and more. http://solutions.newsforge.com/ibmarch.tmpl
_______________________________________________
Net-snmp-users mailing list
[email protected]
Please see the following page to unsubscribe or change other options:
https://lists.sourceforge.net/lists/listinfo/net-snmp-users