mib2c config file format - testing read-only

Hi,
 
Is the mib2c config file format published anywhere, or is it just a case
of looking at the mib2c source code? I note that the manual page reads
as though the config files shipped with NetSNMP are really part of
mib2c, but presumably it's not that hard to tweak it to your own design?
One particular thing I'd like to know, how do you test if an object's
access mode (in particular if it is read-only).
 
Thanks in advance
 
Raffles
 
PS After the horrible formatting of the last two messages, I'm sending
this as an smime e-mail. This should hopefully prevent our mail gateway
mangling the message - I think the html tags are getting added somewhere
else in the chain actually, but I'm guessing they're caused by the
auto-attached company disclaimer that gets added by our lovely gateway.

-- 

Visit our website at www.roke.co.uk

Roke Manor Research Ltd, Roke Manor, Romsey, Hampshire SO51 0ZN, UK.

The information contained in this e-mail and any attachments is proprietary to
Roke Manor Research Ltd and must not be passed to any third party without
permission. This communication is for information only and shall not create or
change any contractual relationship.