Configuration need in order to recieve snmp traps

 
Hello all,

I am able to communicate with the snmp device which i am having but not able to recieve the traps generated by the device

In the FAQ I have seen that in order to recieve snmp traps I need to configure snmptrapd 

But it is not working 

I am getting the error given below

No log handling enabled - turning on stderr logging
Cannot find module (TRAP-TEST-MIB) : At line 0 in (none)
/usr/local/share/snmp/snmptrapd.conf:line 38 : Error : Bad trap OID in traphandler directive: TRAP-TEST-MIB::demo-trap
net-snmp: 1 error(s) in config file(s)
Warning : no access control information configured.
This reciever will *NOT* accept any incomming notifications.

I am looking out for solution
It seems to be that the snmptrad.conf is not correct
in order to recieve a trap message from 192.168.1.50 device 
what is the configuration to be needed

thanks in advance

looking for result ASA


 
Thanks & Regards,
 
Santhosh Kumar Suddavanda

Mail :  [email protected]