Re: how to use HOST-RESOURCES-MIB

On 10/11/06, Bruce Shaw <[email protected]> wrote:
> You need to make sure it's actually compiled in.  On most platforms it is.

But that depends on the version of the software.
The 'host' module was only added to the default build with release 5.3.
Given that Khalid is using 5.2.1, it won't be included automatically,
and needs to be explicitly added.


> Finally, your invocation did not include the MIB you wanted to see, so it
> returned the default, which may not include HRM data.

No - that should be fine.
A simple "snmpwalk" with no explicit starting OID will walk the 'mib-2' tree
(i.e. .1.3.6.1.2.1).  This covers the Host Resources information
(.1.3.6.1.2.1.25).

It's only vendor-specific MIBs (and SNMP infrastructure) that tends to
be sited outside this tree - IETF-standard MIBs would normally be covered
by this default walk.


Dave

-------------------------------------------------------------------------
Using Tomcat but need to do more? Need to support web services, security?
Get stuff done quickly with pre-integrated technology to make your job easier
Download IBM WebSphere Application Server v.1.0.1 based on Apache Geronimo
http://sel.as-us.falkag.net/sel?cmd=lnk&kid=120709&bid=263057&dat=121642
_______________________________________________
Net-snmp-users mailing list
[email protected]
Please see the following page to unsubscribe or change other options:
https://lists.sourceforge.net/lists/listinfo/net-snmp-users