Re: where to set retries/timeout time, problem in set request
"Dave Shield" <[email protected]>
| Newsgroups | gmane.network.net-snmp.user |
|---|---|
| Message-ID | <[email protected]> |
On 16/01/2008, Awadhesh Kumar <[email protected]> wrote: > It is showing that two SET request has been sent to sub-agent(Might be I am > wrong). Seems that client is sending the request two times That makes sense. If the client sends the request twice, then the master agent will send the sub-request twice (once for each incoming request). > but if I give > command "snmpset -r 0 ...." then it gives timeout error. Try increasing the timeout as well. > And replacing the > 0 with 1 it is sending the request to master agent two time as you've told it to.... > and getting the response. So the initial response *almost* gets back in time. Increasing the timeout value should be sufficient. > Is there any way to avoid the multiple request sent by client to > master agent in net-snmp Increase the client timeout. > because my client would be some third party client > like "emanate" snmp client You'll need to check the documentation for that client to see how to set the retry/timeout values. Dave ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2008. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ Net-snmp-users mailing list [email protected] Please see the following page to unsubscribe or change other options: https://lists.sourceforge.net/lists/listinfo/net-snmp-users