The problem of Bridge MIB

Hello, everyone:

I'm using Bridge MIB to get the MAC-Port mapping in my switch (Catalyst
2900xl, IOS 12.0(5.1)XP ). I use
mgmt.mib-2.dot1dBridge.dot1dTp.dot1dTpFdbTable (1.3.6.1.2.1.17.4.3.1) to get
such mapping. The problem is I can only get the mapping from the default
vlan (vlan1). I used "show mac" in the command line and found there're
mappings in other vlans.  I tried to use community indexing as "snmpwalk -v
2c -c public@3 192.168.49.2 .1.3.6.1.2.1.17.4.3.1", where public@3 eans
vlan3 and 192.168.49.2 is the switch's management IP. But it always replies
"Timeout: No response from 192.168.49.2". Even I use the same command with
indexing to vlan1, the same reply.

 

I searched in the web and found some people met such problem before, but I
cannot search a solution. Does anybody here met such problem and any
solutions for it? Thanks a lot!

 

BRs

Jim

------------------------------------------------------------------------------
SF.Net email is Sponsored by MIX09, March 18-20, 2009 in Las Vegas, Nevada.
The future of the web can't happen without you.  Join us at MIX09 to help
pave the way to the Next Web now. Learn more and register at
http://ad.doubleclick.net/clk;208669438;13503038;i?http://2009.visitmix.com/

_______________________________________________
Net-snmp-users mailing list
[email protected]
Please see the following page to unsubscribe or change other options:
https://lists.sourceforge.net/lists/listinfo/net-snmp-users