Re: send_v2trap not working w/ snmp-target-mib
"Dave Shield" <[email protected]>
| Newsgroups | gmane.network.net-snmp.user |
|---|---|
| Message-ID | <[email protected]> |
2009/1/12 bigschwansb <[email protected]>: > trap2sink entries added in snmpd.conf work fine and traps are sent w/o > problem, however the same traps are not sent to entries added via the > target-mib "targetAddr"/"targetParams". What are the exact command(s) you are using to add these new entries? Are you adding an entry to the snmpNotifyTable? What do the commands: snmptable .... snmpTargetAddrTable snmptable .... snmpTargetParamsTable snmptable .... snmpNotifyTable show a) Before setting up the new target? b) After setting up the new target? Dave ------------------------------------------------------------------------------ Check out the new SourceForge.net Marketplace. It is the best place to buy or sell services for just about anything Open Source. http://p.sf.net/sfu/Xq1LFB _______________________________________________ Net-snmp-users mailing list [email protected] Please see the following page to unsubscribe or change other options: https://lists.sourceforge.net/lists/listinfo/net-snmp-users