Problem in using Counter64
umashankar tm <[email protected]>
| Newsgroups | gmane.network.net-snmp.user |
|---|---|
| Message-ID | <[email protected]> |
Hi,
In my MIB I have a variable defined as Counter64. when I generate code using mib2c, it is converted to U64. I am assigning xxx.high = 1 and xxx.low=100.
rowreq_ctx->data.xxx.high = 1;
rowreq_ctx->data.xxx.low = 100;
If I do snmpget I will get the output as 1. ie only xxx.high is displayed. Please let me know am I missing out anything or point me to some relevent on docs.
Regards,
Umashankar
Add more friends to your messenger and enjoy! Go to http://messenger.yahoo.com/invite/
------------------------------------------------------------------------------
Check out the new SourceForge.net Marketplace.
It is the best place to buy or sell services for
just about anything Open Source.
http://p.sf.net/sfu/Xq1LFB
_______________________________________________
Net-snmp-users mailing list
[email protected]
Please see the following page to unsubscribe or change other options:
https://lists.sourceforge.net/lists/listinfo/net-snmp-users