[IPv6] AgentAddr and snmpd.conf

Hi everyone,
sorry in advance for my bad english.

I try to use 'agentaddress' on my snmpd.conf file ( for some reasons, I 
prefer to use agentaddress than com2sec6 ) but the server don't respond 
to my IPv6 requests.

My access configuration for snmpd.conf :

    agentaddress     udp6:::1,tcp6:::1
    rocommunity    public


How i'm running the server :
   
    snmpd -f -d -Dread_config -c /usr/local/share/snmp/snmpd2.conf

And how i test if the server respond to my IPv6 requests :

    snmpwalk -c public -v 2c udp6:::1 .1.3.6.1.2.1.1.1

I have a timeout from the answer.

If i use com2sec, group, view and access tokens instead of agentaddress 
and rXcommunity and if I run the server like that :
   
    snmpd -f -d -Dread_config -c /usr/local/share/snmp/snmpd2.conf udp6:161

I have a correct answer from the server but i would like to know if i 
can have the same result by using agentaddress and rocommunity tokens.

Thanks in advance.

Aurélien ANSEL.

------------------------------------------------------------------------------
Crystal Reports - New Free Runtime and 30 Day Trial
Check out the new simplified licensing option that enables unlimited
royalty-free distribution of the report engine for externally facing 
server and web deployment.
http://p.sf.net/sfu/businessobjects
_______________________________________________
Net-snmp-users mailing list
[email protected]
Please see the following page to unsubscribe or change other options:
https://lists.sourceforge.net/lists/listinfo/net-snmp-users