Re: how to register new mibs?
Irvs <[email protected]>
| Newsgroups | gmane.network.net-snmp.user |
|---|---|
| Message-ID | <[email protected]> |
Thanks Dave for the reply. Actually I have an installed net-snmp and as much as possible I don't want to re-run the ./configure since it can create a problem. The case here is avoiding re-running ./configure to not compromise the current implementation. Is it possible that there are just files I need to modify to accommodate the new mibs? Bong On Fri, Jun 19, 2009 at 4:41 PM, Dave Shield <[email protected]>wrote: > 2009/6/19 Irvs <[email protected]>: > > I am very new to using Net-Snmpd. I was able to generate newmodule.c and > > newmodule.h using the mib2c command in linux. And I noticed that > somewhere > > in the code is the init_newmodule() where the new mib registration > happens. > > I wonder where this function must be called? What file should I edit to > have > > the new mibs registered during start up of net-snmpd. > > If you run the command > configure --with-mib-modules=newmodule > > then this will add your new module to the build framework. > See the FAQ entry "Where should I put the files produced by 'mib2c'?" > for more information. > > Dave > ------------------------------------------------------------------------------ Are you an open source citizen? Join us for the Open Source Bridge conference! Portland, OR, June 17-19. Two days of sessions, one day of unconference: $250. Need another reason to go? 24-hour hacker lounge. Register today! http://ad.doubleclick.net/clk;215844324;13503038;v?http://opensourcebridge.org _______________________________________________ Net-snmp-users mailing list [email protected] Please see the following page to unsubscribe or change other options: https://lists.sourceforge.net/lists/listinfo/net-snmp-users