RE: How to send V3 traps from enterprise MIB modules?

> From: Joan Landry [mailto:[email protected]]

> I am doing the same thing and have found after several days of trial
and
> error that the following works for sending v3 traps in snmpd.conf
> Instead of using trap2sink you need to use:
> trapsess -l authPriv -u v3user2 -a MD5 -A abcdefgh -x DES -X abcdefgh

  Ah, thanks.  I will give that a try.  I didn't realize I was following
in your footsteps THAT closely. ;)

> Only I see no way to get filtering to work.

  I was scared off notification filtering a long time ago, and have
luckily not had to bother with it.  (In other words, I read your last
question to the list but have no idea how to fix it.)

  Good luck, and thanks again for the tip.

  Ron



The information contained in this message may be privileged and confidential and protected from disclosure. If the reader of this message is not the intended recipient, or an employee or agent responsible for delivering this message to the intended recipient, you are hereby notified that any dissemination, distribution or copying of this communication is strictly prohibited. If you have received this communication in error, please notify us immediately by replying to the message and deleting all copies. Thank you.

------------------------------------------------------------------------------

_______________________________________________
Net-snmp-users mailing list
[email protected]
Please see the following page to unsubscribe or change other options:
https://lists.sourceforge.net/lists/listinfo/net-snmp-users