snmpd MIB Question

Hi All,

I have I think a very basic question.  I've been chasing around on this 
for a couple of days.

I am setting up a custom monitor command in snmpd.conf.  As long as I 
supply numeric OIDs, it works fine.  However, if I supply a name in 
place of the OID, from an MIB file that resolves just fine with 
snmptranslate, snmpd throws a configuration error saying it can't find 
the OID.  I can see in the -Dread_config output of snmpd that it is 
seeing and loading my custom MIB file, and obviously snmptranslate is 
seeing it as well.

The question is this.  Should I be able to do this, or does the mib2c 
command get involved and I have to set up the .h and .c files in 
agent/mibgroup?  I'm really hoping creating the .c file isn't required 
and that I just have some other minor mis-configuration.

After spending a couple days reading and playing with it, I just was 
hoping for some confirmation from the group.

Thanks,
Doug


_______________________________________________
Net-snmp-users mailing list
[email protected]
Please see the following page to unsubscribe or change other options:
https://lists.sourceforge.net/lists/listinfo/net-snmp-users