Re: Support for SNMP source trap address
Bill Fenner <[email protected]>
| Newsgroups | gmane.network.net-snmp.user |
|---|---|
| Message-ID | <CAF4Soga9XrxuARxjz-R65xZWZuH9QiD0i6Lbr3ZKPt4FkLfodw@mail.gmail.com> |
-s on trapsess lines will override clientaddr. Bill On Sun, Sep 8, 2019 at 1:15 PM Nitin Samuel <[email protected]> wrote: > Thanks Bill. > > So in 5.8, if I have [snmp] clientaddr <> at the top, followed later by > a few trapsess hosts but one of which has the new '-s <>' option, will > clientaddr token be honored for this trap host ? > > On Sun, Sep 8, 2019 at 4:21 PM Bill Fenner <[email protected]> wrote: > >> On Fri, Sep 6, 2019 at 4:56 PM Chinnapareddygari, Chandrasekharreddy < >> [email protected]> wrote: >> >>> I am using net-snmp 5.7.2 in my project..I want to use SNMP trap source >>> as user configured IP address. >>> How can I achieve this ? >>> >> >> In 5.7.2 you can use the “clientaddr” configuration in snmpd.conf to set >> the source of trap messages. In 5.8, each trap configuration (e.g., >> trapsink, trapsess) can accept a source address argument as “-s foo”. >> >> Bill >> >>> _______________________________________________ >> Net-snmp-users mailing list >> [email protected] >> Please see the following page to unsubscribe or change other options: >> https://lists.sourceforge.net/lists/listinfo/net-snmp-users >> > _______________________________________________ Net-snmp-users mailing list [email protected] Please see the following page to unsubscribe or change other options: https://lists.sourceforge.net/lists/listinfo/net-snmp-users