Re: Support for SNMP source trap address

Good point, Chandra - in snmpd.conf, the configuration has to be

[snmp] clientaddr ___

  Bill


On Tue, Sep 10, 2019 at 12:27 PM Chinnapareddygari, Chandrasekharreddy <
[email protected]> wrote:

> Thanks Bill,
>
> It's working fine after adding clienaddr <address> in snmp.conf .but it is
> not working with snmpd.conf
>
> Does any extra changes required ?
>
>
> Thanks,
> Chandra.
> Get Outlook for Android <https://aka.ms/ghei36>
>
>
>
> From: Bill Fenner
> Sent: Sunday, 8 September, 16:20
> Subject: Re: Support for SNMP source trap address
> To: Chinnapareddygari, Chandrasekharreddy
> Cc: [email protected]
>
>
> On Fri, Sep 6, 2019 at 4:56 PM Chinnapareddygari, Chandrasekharreddy <
> [email protected]> wrote:
>
> I am using net-snmp 5.7.2  in my project..I want to use SNMP trap source
> as user configured IP address.
> How can I achieve this ?
>
>
> In 5.7.2 you can use the “clientaddr” configuration in snmpd.conf to set
> the source of trap messages. In 5.8, each trap configuration (e.g.,
> trapsink, trapsess) can accept a source address argument as “-s foo”.
>
>   Bill
>
>
>

_______________________________________________
Net-snmp-users mailing list
[email protected]
Please see the following page to unsubscribe or change other options:
https://lists.sourceforge.net/lists/listinfo/net-snmp-users