Re: Re: Netsaint doesn't start anymore ! (SIGSEGV)

Stanley Hopcroft wrote:
>
> This system has been updated with cvsup/make buildworld since about 4.6
> and I have only had minor problems with Netsaint (close handles on exec
> with check_by_ssh was the only issue) during that period.
> 
> Can you get a backtrace
> 
> cd <netsaint/bin>
> gdb netsaint
> set args -v /usr/local/etc/netsaint.cfg
> r
>  ...SEGV..
> bt
> 
> ?


Hi Stanley,


I get this here:
NetSaint 0.0.7 starting... (PID=84434)
Warning: Contact group 'switch-admins' is not used in any hostgroup or
service definitions or escalations!
(no debugging symbols found)...(no debugging symbols found)...
Program received signal SIGSEGV, Segmentation fault.
0x28159608 in strtoul () from /usr/lib/libc.so.4
(gdb) bt
#0  0x28159608 in strtoul () from /usr/lib/libc.so.4
#1  0x805a636 in xrddefault_read_state_information ()
#2  0x8059102 in read_initial_state_information ()
#3  0x8049d9d in main ()
#4  0x8049415 in _start ()
(gdb) 


Might be a problem in a config-file...
But where ? ...



Thanks anyway.

cheers,
Rainer
-- 
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Rainer Duffner                   Munich
[email protected]          Germany
http://www.i-duffner.de        Freising
========================================
All HTML-mail goes to my pre-trash bin !
Send plain text email for faster response
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~


-------------------------------------------------------
This SF.net email is sponsored by:Crypto Challenge is now open! 
Get cracking and register here for some mind boggling fun and 
the chance of winning an Apple iPod:
http://ads.sourceforge.net/cgi-bin/redirect.pl?thaw0031en