Re: AP hopping & hiding clients from each other
"Matt Buford" <[email protected]>
| Newsgroups | gmane.network.nocat |
|---|---|
| Message-ID | <011c01c508bc$613e16a0$fe00000a@speedy> |
You can set up some switches so that ports can't see each other, while still all being able to see the uplink/router (See "private vlans" and "private vlan edge" on Cisco switches). So, if you have multiple APs and configure them to block communication between AP clients, then the switch can take care of inter-AP communication and you should be all set. ----- Original Message ----- From: "worldwidewait" <[email protected]> To: <[email protected]> Sent: Sunday, January 30, 2005 4:40 AM Subject: Re: [NoCat] AP hopping & hiding clients from each other > DeWayne Mangan sagte: >> >> I want everyone to be able to bond to my APs, but I >> don't want them to be able to "see" each other - I just want them to be >> able to go to the internet. > > You can setup some AP's to hide the clients from each other. But this will > only affect clients connected to the same AP. > _______________________________________________ > NoCat mailing list > [email protected] > http://lists.nocat.net/mailman/listinfo/nocat >