[c-nsp] 'show ip arp' intended functionality
Drew Weaver <[email protected]>
| Newsgroups | gmane.network.nsp.cisco |
|---|---|
| Message-ID | <[email protected]> |
Hello, This is more of a curiosity rather than an actual technical question. How *should* the command 'show ip arp' function? I've noticed that on almost all network operating systems the 'show ip arp' command (or it's equivalent) shows the device (router/switch/whatever) in the table. On NX-OS and Dell 10 Enterprise it only shows the hosts connected to the interface (and not switch/routers own IP) I am mostly just curious as to "what is correct" also if anyone is aware of a command in NX-OS or Dell 10 E that shows it 'the old way' please enlighten me! Thanks, -Drew _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/