Re: [c-nsp] 'show ip arp' intended functionality
Giles Coochey <[email protected]>
| Newsgroups | gmane.network.nsp.cisco |
|---|---|
| Message-ID | <[email protected]> |
On 28/10/2021 13:53, Drew Weaver wrote: > Hello, > > This is more of a curiosity rather than an actual technical question. > > How *should* the command 'show ip arp' function? > > I've noticed that on almost all network operating systems the 'show ip arp' command (or it's equivalent) shows the device (router/switch/whatever) in the table. > > On NX-OS and Dell 10 Enterprise it only shows the hosts connected to the interface (and not switch/routers own IP) > > I am mostly just curious as to "what is correct" also if anyone is aware of a command in NX-OS or Dell 10 E that shows it 'the old way' please enlighten me! > I would expect it to show the table of IP addresses and MAC addresses that it has learned via the ARP protocol. Static ARP entries (using configured and BIA MAC addresses) I wouldn't expect to see, unless labelled as "static" as opposed to "dynamic". -- Giles Coochey _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/