Re: using mib group ifType filter not working for cisco switches
onmstester onmstester <[email protected]>
| Newsgroups | gmane.network.opennms.general |
|---|---|
| Message-ID | <[email protected]> |
We used to get the answer in this forum! Good old days!! Sent using Zoho Mail ---- On Thu, 16 Nov 2017 08:38:30 +0330 onmstester onmstester <[email protected]> wrote ---- Hi I need opennms to get ifHcInOctets, ifHcOutOctets and operStatus metrics from only physical interfaces of switch (which having multiple VLANs). I used ifType attribute from mib group tag and used ifType="6" (6 for the ethernet interface) in mib-interface group of mib2.xml. Extreme switch node in opennms only have the mentioned metrics for physical interfaces so its fine but we have problem with cisco nodes. In one of them which the primary interface is ethernet, only that interface have graphs and in another one which primary interface is a VLAN, no metrics for interffaces been gathered. Thanks in advance Sent using Zoho Mail ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot_______________________________________________ Please read the OpenNMS Mailing List FAQ: http://www.opennms.org/index.php/Mailing_List_FAQ opennms-discuss mailing list To *unsubscribe* or change your subscription options, see the bottom of this page: https://lists.sourceforge.net/lists/listinfo/opennms-discuss ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Please read the OpenNMS Mailing List FAQ: http://www.opennms.org/index.php/Mailing_List_FAQ opennms-discuss mailing list To *unsubscribe* or change your subscription options, see the bottom of this page: https://lists.sourceforge.net/lists/listinfo/opennms-discuss