Re: using mib group ifType filter not working for cisco switches

Maybe it’s because your question is hidden in the text and not quite clearly formulated?

If I understand it correctly

Ø  I need opennms to get ifHcInOctets, ifHcOutOctets and operStatus metrics from only physical interfaces of switch (which having multiple VLANs).

So you only want measurements for one Interface per node?


-       You have a filter to collect data only for ifType=”6” interfaces

-       You have a cisco device where the primary interface is a VLAN

-       For this node no interface metrics are collected

Questions:

-       do you have another filter to only collect from the primary interface? (never did this so I don’t know how to do it).

-       Did you check the interface type in the DB, are there any ifType=6 Interfaces active on this node or is this some special config – device with only serial lines or something like this?



Ø  In one of them which the primary interface is ethernet, only that interface have graphs

I this a second issue? You wrote you need “metrics from only physical interfaces of switch” which is exactly what you get here – so this is no issue at all, am I right?


-Michael

------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot

_______________________________________________
Please read the OpenNMS Mailing List FAQ:
http://www.opennms.org/index.php/Mailing_List_FAQ

opennms-discuss mailing list

To *unsubscribe* or change your subscription options, see the bottom of this page:
https://lists.sourceforge.net/lists/listinfo/opennms-discuss