OpenNMS Amount of data in an interface
"Madden, Joe" <[email protected]>
| Newsgroups | gmane.network.opennms.general |
|---|---|
| Message-ID | <LO1P12301MB1571CF2434329FB3D4D76C6B91630@LO1P12301MB1571.GBRP123.PROD.OUTLOOK.COM> |
Hi List, Just wondering if there is a way to raise an alarm on the amount of data used by a particular interface? OpenNMS is able to calculate the information as it Appears in the resource graphs as Tot Out / Tot In on the interface Bits In/Out I guess it uses the Historical information recorded from Bits In/Out to calculate the amount of data used – Is there a way in OpenNMS to query this and alarm on it when it gets to say 25Gb? Cheers Joe. ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Please read the OpenNMS Mailing List FAQ: http://www.opennms.org/index.php/Mailing_List_FAQ opennms-discuss mailing list To *unsubscribe* or change your subscription options, see the bottom of this page: https://lists.sourceforge.net/lists/listinfo/opennms-discuss