Re: [Proftpd-user] Exceptional slowness and lost connections 1.3.6b vs 1.3.5e
Tony Stocker <[email protected]>
| Newsgroups | gmane.network.proftpd.user |
|---|---|
| Message-ID | <CACLi31VPje3P2znQ8uUt8hstBbT0PYTCJH4K9z7kVwJdys=fTQ@mail.gmail.com> |
On Thu, Dec 5, 2019 at 10:00 AM Matus UHLAR - fantomas <[email protected]> wrote: > this could be issue of mod_delay, try using "DelayEngine off" I implemented this statement and it did not change behavior. > Passive mode or port mode? Can be an ipv6 issue. Passive mode with a defined set of passive ports (64000-65000) > >The system in question is running CentOS 6.10 (Final) with the latest > >kernel, 2.6.32-754.24.3.el6.x86_64. > > quite old system. can be something with this system as long. System is still supported, doesn't EOL until next November. No issues with 1.3.5e, only with subsequent versions. > can you try debugging? run proftpd interactively "proftpd -nd10" > and see the results.. I've done this and ran the system for approximately ten (10) minutes capturing debug output. Should I sanitize and post it (it's approximately 10 MiB in size uncompressed)? Or is there something specific I should look for in the file and post? > http://www.proftpd.org/docs/howto/Debugging.html > -- _______________________________________________ ProFTPD Users List <[email protected]> Unsubscribe problems? http://www.proftpd.org/list-unsub.html