[quagga-users 14566] Re: bgp received route not installed into quagga routing table
Qing Wang <[email protected]>
| Newsgroups | gmane.network.quagga.user |
|---|---|
| Message-ID | <CADkK8gtD0voO+-rrRCQ_o7q3MOaf3JVqcKVWWhOB9L8EFdmwmQ@mail.gmail.com> |
To Clarify : I think the route is received, but *rejected by quagga for some reason*, without I setting up any BGP inbound policy rules -- If I run below two commands: *1) show ip bgp neighbors <neighbor-ip-address> received-routes* command displays all BGP received- routes (both accepted and rejected). *2) show ip bgp neighbors <neighbor-ip-address> routes* command displays all BGP received-routes that are accepted after filtering (using route-maps, prefix-lists). The prefix 184.164.241.0/24 exists in "received-routes" output, while not exists in "routes" output. If I understand correctly, it means the prefix is rejected for some reason. However, I dont have any BGP inbound policy ( i,e, route-maps, prefix-lists ). Does anybody have any idea, or have some similar experience about this issue? I really appreciate any help! Qing On Tue, Dec 20, 2016 at 4:59 PM, Qing Wang <[email protected]> wrote: > Hey Group, > > I am a newbee just starting quagga, please forgive me if this question is > dump. > > The problem is : I received bgp route at one quagga instance, while this > received route can not go into the routing table. > > * On one side, the advertised route is : 184.164.241.0/24 > > * After I run "sh neighbor received-routes" at quagga instance on the > other side, I can find 184.164.241.0/24 in the list. I think this > confirms that I do receive the route > If I run "sh ip route" or "route -n", there is no "184.164.241.0/24" > exists. So route 184.164.241.0/24 isn't going to routing table. > > * I already removed all route-map or prefix-list stuff, so there is no > bgp inbound policy exists. > > * zebra daemon and bgpd daemon are running, as shows below. > mininet-vm# sh daemons > zebra bgpd > > * zabra "ip forwarding" is enabled. > > Since I do received the advertised route, I think the problem becomes > zebra configuration ( Please correct me if I am wrong! ). But I couldn't > get it figured after the efforts. I hope I can get some help from here. > Much appreciation of your time! > > Qing > > > > > > > > > > > > _______________________________________________ Quagga-users mailing list Quagga-users-UOy77sIEA+cAd7ICUelF/[email protected] https://lists.quagga.net/mailman/listinfo/quagga-users