Re: [rancid] problems with PowerConnect switches

> -----Original Message-----
> From: heasley [mailto:[email protected]]
> Sent: Friday, December 07, 2018 3:06 PM
> To: Wayne Eisenberg <[email protected]>
> Cc: '[email protected]' <[email protected]>
> Subject: Re: [rancid] problems with PowerConnect switches
> 
> Fri, Dec 07, 2018 at 10:18:54AM +0000, Wayne Eisenberg:
> > Hi,
> >
> > I have a PowerConnect 5448 that I am having trouble with. If I run the steps
> manually it's fine, but using rancid-run always fails.
> >
> > The router.db file is:
> > pc5448;powerconnect;up
> >
> > The etc/rancid.types.conf section is:
> >
> > powerconnect;script;rancid -t powerconnect powerconnect;login;clogin
> > powerconnect;module;dell powerconnect;inloop;dell::inloop
> > powerconnect;command;dell::GetSystem;show system
> > powerconnect;command;dell::GetConf;show running-config
> >
> > and all the info in .clogin is fine.
> >
> > If I manually run clogin for that switch, it has no problems. Then running
> 'show system' and 'show running-config' gives no problems.

> 
> meaning that
> clogin -c 'show system;show running-config' hostname completes w/o a
> timeout?  if so, that implies to me that either a pager is involving itself in an
> unrecognized manner or there is other unrecognized input preventing it
> from finding the prompt reliably, possibly due to TERM settings (and poor
> defaults).  that could be tested, or it might debugging to, run that clogin from
> cron to see how it acts w/o a terminal.
> 

That results in:

User Name:admin
Password:************

console#
console# terminal length 0
% Unrecognized command

What is issuing the 'terminal length 0' command?

Wayne


_______________________________________________
Rancid-discuss mailing list
[email protected]
http://www.shrubbery.net/mailman/listinfo/rancid-discuss