Re: [rancid] login problem on cisco switch
Wayne Eisenberg <[email protected]>
| Newsgroups | gmane.network.rancid |
|---|---|
| Message-ID | <SN1PR13MB0269B96F783C09FF0E28A7B1E2A60@SN1PR13MB0269.namprd13.prod.outlook.com> |
> We ran into a similar problem recently with one (of over 200) 3850 stack. Suggest you run each of the command that rancid runs after the clogin. > > In our case, the "show version" command was taking too long and reported that it could not figure out how long one of the switches in the stack was up. There were other log entries that pointed to a messed up control plane. A > simple maintenance window switch reboot got "show version" to work - rancid as well. I see the same issue here as with the other one. It doesn't like the 'terminal length 0' command. What to do? $ bin/clogin -c'show version' san-switch01 User Name: **** Password:**************** San-Switch01# San-Switch01#terminal length 0 % Unrecognized command _______________________________________________ Rancid-discuss mailing list [email protected] http://www.shrubbery.net/mailman/listinfo/rancid-discuss