[rancid] end of run not found
Wayne Eisenberg <[email protected]>
| Newsgroups | gmane.network.rancid |
|---|---|
| Message-ID | <CY1PR13MB0266C26992A7F45DAD2DCBF4E2A00@CY1PR13MB0266.namprd13.prod.outlook.com> |
Regarding some PowerConnect N2000/3000/4000 series switches, I am getting "End of run not found" errors. If I use the smc type that is recommended in the rancid.types.base file, I have the added pleasure of getting "missed cmd(s): show version, dir, show vlan". Trying cisco as a type doesn't change the 'end of run' error, although I don't miss any commands. Trying my powerconnect type that I made earlier also results in 'end of run not found'. Running 'clogin -c"dir,show version,show running-config" switchname' works perfectly and returns to the command prompt. How do I troubleshoot 'end of run not found'? _______________________________________________ Rancid-discuss mailing list [email protected] http://www.shrubbery.net/mailman/listinfo/rancid-discuss