Re: [rancid] [SPAM?] Cisco NX "chatty" with Power info

Thu, Jun 27, 2019 at 12:07:13AM -0400, FF:
> ok,
> 
> So upgraded to 3.9 with the same behavior.
> 
> Built a cisco-nxp personality that had an | exclude OK line on it to remove
> the wattage line... but suddenly rancid couldn't log in to those units.
> Even though clogin would work fine. Went and modified the cisco-nx
> definition... but the exclude is ignored.
> 
> So now 2.3 and 3.9 behave identically in this situation...
> 
> This is the whole output for the section in question:
> 
> Index: configs/10.10.10.114
> 
> ===================================================================
> 
> retrieving revision 1.1157
> 
> diff -u -4 -r1.1157 10.10.10.114
> 
> @@ -80,10 +80,10 @@
> 
>   !Env: Power                              Actual        Total
> 
>   !Env: Supply    Model                    Input      Capacity       Status
> 
>   !Env:                                    (Watts )     (Watts )
> 
>   !Env: -------  ----------  ---------------  ------  ----------
> --------------------
> 
> - !Env: 1        N9K-PAC-1200W-B                     192 W      1200 W
> Ok
> 
> - !Env: 2        N9K-PAC-1200W-B                     174 W      1200 W
> Ok
> 
> + !Env: 1        N9K-PAC-1200W-B                     190 W      1200 W
> Ok
> 
> + !Env: 2        N9K-PAC-1200W-B                     176 W      1200 W
> Ok
> 
>   !Env: Power Usage Summary:
> 
>   !Env: --------------------
> 
>   !Env: Power Supply redundancy mode (configured)
> PS-Redundant
> 
>   !Env: Power Supply redundancy mode (operational)
> PS-Redundant
> 
> Any suggestions?
> 
> Thanks in advance!
> 

i dont see the problem.  please send the raw output as an attachment to me.

clogin -c 'show environ power' hostname > output

_______________________________________________
Rancid-discuss mailing list
[email protected]
http://www.shrubbery.net/mailman/listinfo/rancid-discuss