Re: Antwort: siproxd zyxel2000W problems

On Monday 10 January 2005 18:17, [email protected] wrote:
> This does not seem to be a problem with your phone. I have exactly the
> same problem with the xten softphone and sipgate, but not with 1und1:
> I can call the 10000 number - ok
> I can be called with my sipgate number from outside
> But I cannot place a call. Get the error message from sipgate.
> No problems with 1und1 with the same configuration.
I also could not get Siproxd to work with Sipgate (with exactly the same 
symptoms). I tried to figure out for a _very_ long time why that is the case 
and I think I narrowed it down to the following: Siproxd adds a second VIA 
header to every SIP Message it sends out (just as it is required by the 
protocol) and Sipgate somehow has a problem with that. Sending out an INVITE 
with just one VIA header worked fine all the time, whereas exactly the same 
message with 2 VIA headers always failed. Personally, I gave up at that point 
and installed Asterisk on my router.

However, I would suggest you try the Sipgate support, as it is quite likely a 
problem with _their_ configuration ...

-- 
Thomas Zell

GPG Key: 2F528D7184975F94
Fingerprint: 363A 7DA7 AAAD FD5D B1E2 4246 2F52 8D71 8497 5F94
sip: [email protected] or +490221355337678

-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.2.4 (GNU/Linux)

iD8DBQBB4vTBL1KNcYSXX5QRAoQXAJ4npRvWeTcC+E3xgbh4dn5nVxQ9cwCeLkBp
v+IrcbAJM6YMu1N6HgyhyK4=
=LckQ
-----END PGP SIGNATURE-----