Re: Tight VNC not responding after IP change( Windows Server 2012 R2)
Hogren <[email protected]>
| Newsgroups | gmane.network.tight-vnc.general |
|---|---|
| Message-ID | <[email protected]> |
Le 09/02/2016 04:28, Nishan Perera : > > Hi all, > > I have install Tight VNC latest version on Windows Server 2012 R2 and > it was working fine. Later I change the IP address (IPV 4) now can not > connect with the server using Tight VNC viewer. How can I correct this > problem? > > Thank you > Nishan > Hello Nishan, What is your physical configuration ? What is between your two machines (a switch, a router, a WAN, etc.) ? Did you restart the service ? Did you restart your server ? Give us as much information as possible. Bye ! Hogren ------------------------------------------------------------------------------ Site24x7 APM Insight: Get Deep Visibility into Application Performance APM + Mobile APM + RUM: Monitor 3 App instances at just $35/Month Monitor end-to-end web transactions and take corrective actions now Troubleshoot faster and improve end-user experience. Signup Now! http://pubads.g.doubleclick.net/gampad/clk?id=272487151&iu=/4140 ___________________________________________________________ TightVNC mailing list, [email protected] To change your subscription or to UNSUBSCRIBE, please visit https://lists.sourceforge.net/lists/listinfo/vnc-tight-list