Re: Window size limits
Robert McConnell <[email protected]> Fri, 21 May 2021 07:21:24 -0400
| Newsgroups | gmane.network.tight-vnc.general |
|---|---|
| Message-ID | <[email protected]> |
On 5/20/21 1:06 PM, Pencoys wrote: > on the pc, open vnc but dont connect to anything. select options and then > 'Display' auto-scale. > it works for me using one PC communicating with four local RPi's and one > remote. > > You can also set the remote RPi's screen resolution either by editing the > /boot/config.txt file or from the RPI desktop using the Raspberry Pi > configurator if less than RPi4 or the 'RPi4 dual screen setup utility. > RTFM usually works. > hth, atb Mike > > On 20 May 2021 at 7:42, Robert McConnell wrote: > > To: "[email protected]" > <[email protected]> > From: Robert McConnell <[email protected]> > Subject: Window size limits > Date sent: Thu, 20 May 2021 07:42:42 -0400 > >> Good morning, >> >> I am using tightvnc on Slackware to connect with a pair of Raspberry >> Pi's running x11vnc. Everything is working well, except for one minor >> irritation. >> >> The HDMI displays on the Pi's are both 1360x768 pixels. The VGA flat >> panel display on the Slackware box is 1280x1024. Tightvnc will not allow >> me to increase the viewer window height far enough to eliminate the >> vertical scroll bar. Dragging the top or bottom edge and resize both >> stop expanding just a few pixels short of the full image height. >> >> What am I missing? >> >> Thank you, >> >> Bob McConnell >> N2SPP 'vncviewer' with no options pops up a server dialog box that asks for an address. There are no buttons, menu bar or other decorations on the box. Just pressing enter returns to the command line with "Connection refused" I've been working from the man page, but that doesn't tell me much other than some of the command line options. I can't find any way to get an options dialog or any vnc specific menus once the viewer is connected to a host. -- Bob McConnell N2SPP ___________________________________________________________ TightVNC mailing list, [email protected] To change your subscription or to UNSUBSCRIBE, please visit https://lists.sourceforge.net/lists/listinfo/vnc-tight-list