Re: Binhex files .sit

I think what is happening is that ubh is looking for either
uuencoded or yencoded data.  I think the .txt file probably
just contains the headers.

I would recommend dumping the files with -D and
go back later and run uudeview on the resulting file(s).
If uudeview does not decode those, then I think the data
inside is not in the format you think it is, and probably
needs some more translation (.sit -> binhex?) before
uudeview can decode them.

-Gerard


--- RT <[email protected]> wrote:
> How do i use ubh to accept sit files that are in binhex format ?
> ubh skips all of them, after assembling, it is in 
> a txt format. If ubh accepts the txt file, and i manually run 
> uudeview on the txt i get an error - No End Found. How do i get it 
> to convert the txt back to sit without skipping. Should i use tools 
> like hex2bin
> 
> thanks
> 
>  
> 
> 2003/04/25 02:55:07 ubh.decode.MIME INFO> Subject: - 1.2.5 muinatiT 
> tsaoT.03.sit
> (01/15) Thanks to Doc_
> 2003/04/25 02:55:13 ubh.save_file INFO> Skipping file with unwanted 
> extension: msg-2229-315.txt
> 
> 


------------------------ Yahoo! Groups Sponsor ---------------------~-->
Get 128 Bit SSL Encryption!
http://us.click.yahoo.com/W7NydA/hdqFAA/bW3JAA/IHFolB/TM
---------------------------------------------------------------------~->

To unsubscribe from this group, send an email to:
[email protected]

 

Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/