Re: skip deletes

Hi Adam,

Not sure I understand what you are trying to do. Starting over without
considering any previous state can be achieved by the 'ignorearchives'
preference. On the command line you can just add -ignorearchives as an
argument. But you can also add ignorearchives = true in the profile for use
in GUI, for example. This preference should be used only once and then
removed, otherwise every sync will be considered to be a "first run".
Alternatively, the same can be achieved by deleting the archive files for
both roots, if you know where to find them.

On Thu, 29 Aug 2024 at 17:21, Adam Barnett <[email protected]> wrote:

> Thanks, unfortuanlly that did not work , as it was a one time delete, and
> should not happen again is there a way to get unison to rebuild the replica
> so it does not see the delete files anymore ?
>
> On Mon, 12 Aug 2024 at 13:17, Adam Barnett <[email protected]> wrote:
>
>> Thanks, unfortuanlly that did not work , as it was a one time delete, and
>> should not happen again is there a way to get unison to rebuild the replica
>> so it does not see the delete files anymore ?
>>
>>
>>
>> On Fri, 2 Aug 2024 at 14:35, Tõivo Leedjärv <[email protected]> wrote:
>>
>>> On Fri, 2 Aug 2024 at 15:09, Adam Barnett <[email protected]> wrote:
>>> >
>>> > Sorry i am looking in : unison-manual.pdf but cannot see an example of
>>> where this is covered , can you provide the  URL?
>>>
>>> It may not be quite what you are looking for, but have a look at the
>>> nodeletion and nodeletionpartial preferences.
>>>
>>

To unsubscribe from this group and stop receiving emails from it, send an email to [email protected].