Re: skip deletes

Perfect, thanks


On Thu, 29 Aug 2024 at 18:48, Tõivo Leedjärv <[email protected]> wrote:

> Hi Adam,
>
> Not sure I understand what you are trying to do. Starting over without
> considering any previous state can be achieved by the 'ignorearchives'
> preference. On the command line you can just add -ignorearchives as an
> argument. But you can also add ignorearchives = true in the profile for use
> in GUI, for example. This preference should be used only once and then
> removed, otherwise every sync will be considered to be a "first run".
> Alternatively, the same can be achieved by deleting the archive files for
> both roots, if you know where to find them.
>
> On Thu, 29 Aug 2024 at 17:21, Adam Barnett <[email protected]> wrote:
>
>> Thanks, unfortuanlly that did not work , as it was a one time delete, and
>> should not happen again is there a way to get unison to rebuild the replica
>> so it does not see the delete files anymore ?
>>
>> On Mon, 12 Aug 2024 at 13:17, Adam Barnett <[email protected]> wrote:
>>
>>> Thanks, unfortuanlly that did not work , as it was a one time delete,
>>> and should not happen again is there a way to get unison to rebuild the
>>> replica so it does not see the delete files anymore ?
>>>
>>>
>>>
>>> On Fri, 2 Aug 2024 at 14:35, Tõivo Leedjärv <[email protected]> wrote:
>>>
>>>> On Fri, 2 Aug 2024 at 15:09, Adam Barnett <[email protected]> wrote:
>>>> >
>>>> > Sorry i am looking in : unison-manual.pdf but cannot see an example
>>>> of where this is covered , can you provide the  URL?
>>>>
>>>> It may not be quite what you are looking for, but have a look at the
>>>> nodeletion and nodeletionpartial preferences.
>>>>
>>>

To unsubscribe from this group and stop receiving emails from it, send an email to [email protected].