Re: Making RH 8.0 work

Hi,

>         Up until about 30 minutes before I commited the latest code, it
> was unstable - mostly because it wasn't doing anything remotely like
> downloading packages for me.  Turned out I'd forgotten to make a change
> in that codebase to compensate for the newer up2date clients that had
> gone into the 1.4 series; once I found that, it started working.

OK, two questions: make install fails at some point:

for d in db ; do make -C $d install ; done
make[2]: Entering directory `/home/jos/current/jwbernin-postgres-branch/current/src/db'
make[2]: *** No rule to make target `current_db.py', needed by `current_db.pyc'.  Stop.
make[2]: Leaving directory `/home/jos/current/jwbernin-postgres-branch/current/src/db'
make[1]: *** [install] Error 2

Pretty fatal, I think, as there is no db now.

Furthermore, what are recommended values for db_type and db_connect,
as the current.conf file is not very clear about this and the docs
don't seem to talk about it.

Digging further...

-- 
--    Jos Vos <[email protected]>
--    X/OS Experts in Open Systems BV   |   Phone: +31 20 6938364
--    Amsterdam, The Netherlands        |     Fax: +31 20 6948204