Re: Cisco 350 AP help, anyone?

Dan,

    Let's try following : 

1. Connect Cisco with it's com port connector - have it connected to a PC's - Com1 port. Configure it with correct data rate. And u will see some message displayed.

2. Reboot the AP.

3. See if you can see some messages. Send it to group. I might be able to debug for you.

4. Now Press a Black Button on the back - Pull the Power on AP ( Reboot ) and this AP should return to it's default settings - Factory settings.

Let me know what happens next.

Shail

>>> "Dan Richardson" <[email protected]> 09/11/04 11:44 AM >>>
I just tried upgrading my bomber-solid-never-fails Cisco 350 Access Point to IOS from
the VxWorks OS it had.  I saw they added WPA, and I wanted to experiment with it.  Yeah,
I knew I was going to get a doorstop in the end... :-(.

Anyway, I'm stuck with 3 SOLID Amber / yellow lights.  Dead as a dodo, as far as I can
tell.  Can't ping it, can't see it.  No workie.

Searched everywhere, but can't find anything out there... anywhere!  So, if anyone has
any help for this guy, please help!

Thanks!!

-Dan
[email protected]




_______________________________________________
BAWUG's general wireless chat mailing list
[unsubscribe] http://lists.bawug.org/mailman/listinfo/wireless

________________________________________________________________________
This email has been scanned for computer viruses.

_______________________________________________
BAWUG's general wireless chat mailing list
[unsubscribe] http://lists.bawug.org/mailman/listinfo/wireless