Re: bsd-airtools on openbsd 3.2

Make sure the card is 'UP'.  On my rig it's only for sniffing so it's 
basically not configured with an ip or anything so I do an 'ifconfig wi0 
up.' You also need to put it in monitor mode. I use "prism2ctl wio -m".

My system is a dell inspiron 7000 with a cisco 350 card. OpenBSD 3.2.

tye

Nick Vahalik wrote:

> Hey all,
>
>
> I'm trying to get my wlan card to work with dstumbler, but I am having 
> some problems.  The network card I am using is the Dell Truemobile 1150:
>
> wi0 at pcmcia1 function 0 "Dell, TrueMobile 1150 Series PC Card, 
> Version 01.01" port 0x400/64: irq 9
> wi0: Firmware 8.10 variant 1, address 00:02:2d:51:38:15
>
> I installed OpenBSD 3.2 (no patches or updated wicontrol) from the 
> cdrom as an upgrade from 3.1 (X kept locking up with apmd).  I 
> installed the bsd-airtools-0.2.tgz package from the OpenBSD packages 
> page.  It installed with no problems.  So, I tried dstumbler: "# 
> dstumbler wi0<enter>", and it came up... but nothing happened.  The 
> lights on the card don't flash, and the only output I get is  "error: 
> unable to ioctl device socket: Invalid argument" when I quit 
> dstumbler.  Do I need to use OpenBSD 3.0 and apply the patches to get 
> it to work?  Or do I need to get invest in a new wlan card?  maybe one 
> of those wpc11's from Linksys?
>
> Thanks
> Nick
>
> _______________________________________________
> Bat mailing list
> [email protected]
> http://lists.dachb0den.com/mailman/listinfo/bat