Re: dstumbler + Openbsd 3.3 + Cisco aironet = "error: unable to ioctl device socket: Invalid argument" ???

It sounds like dstumbler is trying to set a mode that the card doesn't 
support. Have you tried dstumbler with the -o option? are you turing on 
monitor mode in the 350 with another utility?

tye

Dom Devitto wrote:
> I've been trying to get my Cisco aironet 350 PCMCIA card working with
> dstumbler (and/or dwepdump), but though the 'an0' interface is up dwepdump
> (v0.2) doesn't save any packets (or, at least, always saves only a 24 byte
> file) - though netstumbler running next to it shows 2 cisco AP with WEP...?
> 
> When I try "dstumbler an0" I get the message "error: unable to ioctl device
> socket: Invalid argument", and it doesn't show any APs or anything other
> than the menu etc.
> 
> Any ideas for things I could try?
> 
> Thanks in advance,
> Dom
> Dom De Vitto						Desk: 01962 82 3363
> / 716 3363
> Security Consultant					Mobile: 07855 805
> 271
> Operational Security
> mailto:[email protected]
>       [ http://groupintranet.private.ntl.com/networks/security/ ]
> 
> 
> 
> The contents of this email and any attachments are sent for the personal attention
> of the addressee(s) only and may be confidential.  If you are not the intended
> addressee, any use, disclosure or copying of this email and any attachments is
> unauthorised - please notify the sender by return and delete the message.  Any
> representations or commitments expressed in this email are subject to contract. 
>  
> ntl Group Limited
> 
> _______________________________________________
> Bat mailing list
> [email protected]
> http://lists.dachb0den.com/mailman/listinfo/bat