Re: How do I determine wep and what level of wep? What prism2 card is suggested?

On Thursday, July 11, 2002 at 17:44:22, [email protected] wrote:
> 
> Where can I access the archive for this list?

http://lists.dachb0den.com/pipermail/bat/

> 
> Compaq M300 w/expansion base
> OpenBSD 3.0

Should upgrade to 3.1 STABLE

> Linksys WPC11(v2.5) Wont assign itself to wi0 when booting - I'm new to
> BSD. It detects the card when I insert it, but says device 0 is
> unconfigured.
> I also have an Orinoco Gold - installs fine (but has no RF monitor mode as
> far as I can tell)

Only prism2 cards go into monitor mode

> 
> I'm able to load and use dstumbler.
> My question...finaly:
> How do I determine if wep is enabled and what level?
> What is the "suggested" Prism2 card to use?

I like the SMC's but that is just me. 

-Ron