Re: Sveasoft & WRT54G Tx power rating
crispin <[email protected]>
| Newsgroups | gmane.network.wireless.seattle.devel |
|---|---|
| Message-ID | <BE83E433.802%[email protected]> |
One has to ask if you¹ve already spent the money on an antenna¹s that should greatly expand your range & performance why mess w/adjusting the mw output? If it ain¹t broke don¹t go breaking it. I¹m actually using the Alchemy firmware & have lowered the standard output since I have upgraded 5.5 db antennas. If you¹re trying to cover a large area I¹d say placement of the AP will make a huge difference. I¹ve used settings as high as 100mw or more(w/care to use a band that doesn¹t come close to overlapping other AP¹s channels) w/no ill effect though I imagine in some units cranking up the mw¹s might nuke or eventually shorten the life of the unit . I¹m sure that at 84mw & above noise & distortion might be a significant issue especially in a crowded enviroment where most other AP is set to a default channel of ³6² & your unit is just stepping all over that frequency. Technically I don¹t believe you can play w/the default settings of the mw output of the device & not be violating FCC code. Again that¹s the technicality the Linksys WRT54G was OK¹ed by the FCC at 28mw, I¹m sure they had to jump through hoops to get the 7db antenna¹s approved. Just use common sense, use channels 1-11, & I would take it up to 50mw at the most if you want to cover your whole block or something. Enjoy On 4/13/05 4:10 PM, "[email protected]" <[email protected]> wrote: > I'm a happy guy. Just put Sveasoft's Alchemy-6.0rc6a on my WRT54G v2.2 > > I'm already using the Linksys 7dBi high gain antenna. My question is: how high > can I set the transmission power? The docs are deliberately vague: 48-64 mW > recommended, mixed success reported using 84 mW. > > I want to take advantage of the ability to use higher-than-factory-settings > but don't want to harm the router or offend the FCC. > > Any advice will be greatly appreciated. > > AtDhVaAnNkCsE, > > > Jerry > JetCityOrange > > > _______________________________________________ > Dev mailing list > [email protected] > http://seattlewireless.net/mailman/listinfo/dev > _______________________________________________ Dev mailing list [email protected] http://seattlewireless.net/mailman/listinfo/dev