Re: Senao CB3's gone dead

Bryan Sutton <[email protected]>
Newsgroups gmane.network.wireless.seattle.general
Message-ID <[email protected]>
I have found that by the time I modify an indoor unit to outdoor use, 
it's no cheaper than getting something that is already setup for that 
use from www.demarctech.com . These are not the chepest things out 
there, but, IMHO, they are the best.

Banda wrote:
> I too have been looking for alternative 200mW CPE. I have considered
> using the WRT54G with OpenWRT and the software power boost up. BUT it
> always seemed that CB3s outperformed the WRTs. Any suggestions will be
> very much appriciated.
>
> *** what do you mean by outperformed? on short links (~2 miles), I have yet
> to see more bandwidth on CB3 (11b) than any WRT device (11g). on short
> packets (or packet storms), 11g is also performing better than 11b. don't
> get me wrong - when I don't have perfect LOS and/or have long distance, I
> would always use old lucent or prism based equipment.
> additionally, with openwrt you get linux equiped device, so you can run
> routing and that is rip/ospf dynamic routing if you want/need.
>
>
> _______________________________________________
> Talk mailing list
> [email protected]
> http://seattlewireless.net/mailman/listinfo/talk
>   
_______________________________________________
Talk mailing list
[email protected]
http://seattlewireless.net/mailman/listinfo/talk
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.