Thanks Arnold,
Yes IP forwarding was enabled at R1...I turned it off...let me test again
and will let you know.
PC1: 192.168.101.2 mask 255.255.255.0 dg 192.168.101.1
PC2: 192.168.100.2 mask 255.255.255.0 dg 192.168.100.1
Thanks again
Regards
Sharif
> On 05.06.2006 07:15 [email protected] wrote
>
>> I may be asking a very common question to the list. I have installed
>> quagga-0.99.4 and the daemons are running fine. My intention was to test
>> BGP with 3 zebra router. I started with simple routing through static
>> route to see it is working and I've failed. Bellow are my configuration:
>>
>> ------
>> ps -axf
>> 5701 ? S 0:00 [zebra]
>> 5727 ? S 0:00 [bgpd]
>> 5750 ? S 0:00 [ospfd]
>> 5774 ? S 0:00 [ripd]
>> -------
>>
>>
>> PC--R1--R2--PC
>>
>> R1
>> !
>> interface Ethernet0
>> ip address 192.168.101.1 255.255.255.0
>> !
>> interface Ethernet1
>> ip address 192.168.1.1 255.255.255.0
>> !
>> !
>> ip route 192.168.100.0 255.255.255.0 192.168.1.2
>>
>> R2
>> !
>> interface Ethernet0
>> ip address 192.168.100.1 255.255.255.0
>> !
>> interface Ethernet1
>> ip address 192.168.1.2 255.255.255.0
>> !
>> !
>> ip route 192.168.101.0 255.255.255.0 192.168.1.1
>>
>> I've tested the same at netsim it works fine but at zebra its not. Can
>> someone give me any clue what did i miss at the installation or
>> configuration part?
>>
>
> Do you have ip forwarding enabled on both routers R1 and R2?
> Where does defualt for both PC point to?
>
> --
> Arnold Nipper, AN45
>
lmpx.com only provides a reader for public news (NNTP) servers. It is not
affiliated with the servers or forums shown here and is not responsible for
the content of articles, which is written by their respective authors.