[zebra 22877] Re: Installation or Configuration
Arnold Nipper <[email protected]>
| Newsgroups | gmane.network.zebra |
|---|---|
| Message-ID | <[email protected]> |
On 05.06.2006 08:48 [email protected] wrote > Thanks Arnold, > Yes IP forwarding was enabled at R1...I turned it off...let me test again > and will let you know. > > PC1: 192.168.101.2 mask 255.255.255.0 dg 192.168.101.1 > PC2: 192.168.100.2 mask 255.255.255.0 dg 192.168.100.1 > Of course ip forwardingt has to be turned *on* on both routers! Arnold > Thanks again > Regards > Sharif > > >> On 05.06.2006 07:15 [email protected] wrote >> >>> I may be asking a very common question to the list. I have installed >>> quagga-0.99.4 and the daemons are running fine. My intention was to test >>> BGP with 3 zebra router. I started with simple routing through static >>> route to see it is working and I've failed. Bellow are my configuration: >>> >>> ------ >>> ps -axf >>> 5701 ? S 0:00 [zebra] >>> 5727 ? S 0:00 [bgpd] >>> 5750 ? S 0:00 [ospfd] >>> 5774 ? S 0:00 [ripd] >>> ------- >>> >>> >>> PC--R1--R2--PC >>> >>> R1 >>> ! >>> interface Ethernet0 >>> ip address 192.168.101.1 255.255.255.0 >>> ! >>> interface Ethernet1 >>> ip address 192.168.1.1 255.255.255.0 >>> ! >>> ! >>> ip route 192.168.100.0 255.255.255.0 192.168.1.2 >>> >>> R2 >>> ! >>> interface Ethernet0 >>> ip address 192.168.100.1 255.255.255.0 >>> ! >>> interface Ethernet1 >>> ip address 192.168.1.2 255.255.255.0 >>> ! >>> ! >>> ip route 192.168.101.0 255.255.255.0 192.168.1.1 >>> >>> I've tested the same at netsim it works fine but at zebra its not. Can >>> someone give me any clue what did i miss at the installation or >>> configuration part? >>> >> >> Do you have ip forwarding enabled on both routers R1 and R2? >> Where does defualt for both PC point to? >> >> -- >> Arnold Nipper, AN45 >> > > _______________________________________________ > Zebra mailing list > [email protected] > http://ml.zebra.org/mailman/listinfo/zebra -- Arnold Nipper / nIPper consulting, Sandhausen, Germany email: [email protected] phone: +49 6224 9259 299 mobile: +49 172 2650958 fax: +49 6224 9259 333