[zebra 22901] Re: zebra configration

I think get the hostname and make sure that the password is not the same as
the enable password.

say password = work
      enable password = working

I think that will get you out, ope u removed the comments as well.
If it still fails paste your exact err.. here.

regards Ronald.

On 6/29/06, 龚 露阳 <[email protected]> wrote:
>
> Hi all, I met a problem just now.When I wanted to telnet localhost 2601,
> there was a error message:"Vty password is not set", I had changed the
> zebra.conf.example to zebra.conf.there are two lines in this file:
>     password zebra
>     enable password zebra
> so what is the problem of the erro???
>
> I did it like this:I compile it on my host system, then I copy the bin
> files, man files, configuration files to the target embeded system. and
> "zebra -d" can work fine.Also I try to create a file vtysh.conf in the
> folder /usr/local/etc/. and the content of this file is:
>     username zebra
>     password zebra
>     enable password zebra
>
> but the problem is the same, did some one face the same problem before??
> thanks very much!!
>
>
> Raul
>
> _________________________________________________________________
> 免费下载 MSN Explorer:   http://explorer.msn.com/lccn
>
>
>
> _______________________________________________
> Zebra mailing list
> [email protected]
> http://ml.zebra.org/mailman/listinfo/zebra
>
>
>


-- 
Ronald Nsubuga
Network Engineer
one2net Limited
---------
Everything can be achieved as long you can do what it takes to achieve it! "
The More Things Change The More Things Stay The Same "
----------------------------------------------

_______________________________________________
Zebra mailing list
[email protected]
http://ml.zebra.org/mailman/listinfo/zebra