[zebra 22930] Multipath

Hi,
I have tested static and RIP and it was ok. Now I am trying to test 
OSPF. I am able to get OSPF neighbor from one to one if it is like 
bellow i am not getting all neighbors:

R1
|
|>>>>>>Back to back cross UTP cable
|
R2 (R2 is not getting any neighbor)
|
|>>>>>>Through Hub
|
R3

If i connect R1 directly to R3 its ok but if i go through R2 its not 
working. So i thought its about multipath I recompiled the quagga with 
--enable-multipath=0 and my kernel (2.4) status is as bellow but still 
the result is same.

make menuconfig result

               [*] TCP/IP 
networking                                                                     

                       <M>   Threaded linUX application protocol 
accelerator layer (TUX)                        
                       [*]     External CGI 
module                                                              
                       [ ]     extended TUX logging 
format                                                 
                       [ ]     debug 
TUX                                                                        
                       [*]   IP: 
multicasting                                                                    

                       [*]   IP: advanced 
router                                                             
                       [*]     IP: policy 
routing                                                              
                       [*]       IP: use netfilter MARK value as routing 
key                  
                       [*]       IP: fast network address 
translation                                 
                       [*]     IP: equal cost 
multipath                                                     

Any help would be appreciated.
Thanks in advance
Sharif

-- 
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.
Grameen CyberNet Ltd.