[zebra 23157] FW: Zebra OSPF

Forgive me. I have left some info out below.
 
I want the blades running Zebra to ONLY direct people to the Main OSPF
router.... I do not want my blades to be routing OSPF traffic....
I only want for a packet to come to one of my blades, and instruct the
packet to look at "x" router for direct information.
 
Thanks,
Mathew
 

________________________________

From: Konopinski, Mathew 
Sent: Friday, August 01, 2008 8:59 AM
To: '[email protected]'
Subject: Zebra OSPF


Hi All!
I have recently installed Zebra on my IBM Blades on will primarily be
using Zebra to route OSPF traffic from my mainframe to the blades.
 
I have installed Zebra and I was just reading the instructions. I was
wondering if you could help with this simple config question.
 
In /usr/local/etc I see the sample config files, however I am unsure of
what to specify in these config files exactly.
 
The current ospfd.conf.sample looks like this:
 
 
! -*- ospf -*-
!
! OSPFd sample configuration file
!
hostname ospfd
password zebra
!enable password please-set-at-here
!
!router ospf
!  network 192.168.1.0/24 area 0
!
log stdout

 
What am I supposed to do with this config file? Also where am I supposed
to keep it? Can I just rename it to be ospfd.conf and start the daemon?
 
Many thanks for your assistance.
 
Thanks,
Mathew

_______________________________________________
Zebra mailing list
[email protected]
http://ml.zebra.org/mailman/listinfo/zebra