[zebra 23158] LOG

Folks,
I'm currently running the Zebra Daemon and the OSPFD Daemon on my
server. My only mission
is to have the server build a routing table for OSPF traffic...  It
should only running a pass-along client, I don't want
it acting like the router.
 
Currently I see nothing when I run:
 
Router# show ip route ospf
Codes: K - kernel route, C - connected, S - static, R - RIP, O - OSPF,
       B - BGP, > - selected route, * - FIB route
 
O   43.145.51.0/24 [110/10] is directly connected, bond0, 00:39:17

Where can I go to see the routes its building for the ospf traffic?
 
Perhaps I have my configuration files setup incorrectly?
 
Thanks,
Mathew

_______________________________________________
Zebra mailing list
[email protected]
http://ml.zebra.org/mailman/listinfo/zebra